Configure Layout for SIM in GNSS Receiver

Carlson RT5 | RTk5 Tablet SIM Setup
February 25, 2023
BRx7 Troubleshooting Checklist
April 18, 2023
← Back to help
In this section

Configure Layout for SIM in GNSS Receiver

  1. Open the Carlson Layout Dashboard.
  2. Select your GNSS receiver from the list of devices and press the Configure icon or press the plus icon if it is not listed.
  3. Select your GNSS Manufacturer and Model.
  4. Select the Bluetooth ID for your GNSS receiver.
  5. Advance to the RTK tab and select “Internal GSM” or “Receiver GSM” as the Device.
  6. Press the Configure button on the Device line.
  7. Select “User” as the APN Provider and flolive.net as the APN Server. Leave other fields blank.
  8. Set Network to the source of your RTK data. Typically this is NTRIP or Listen-Listen.
  9. If the Configure icon is shown on the right side of the Network line, tap it to identify the source of your RTK data.
  10. The combo box and Configure button at the bottom of the RTK tab allow you to select the mountpoint or specific source of your RTK corrections.
  11. Press Done to start communications with the GNSS receiver and start streaming RTK corrections to it.
  12. Check that RTK corrections are streaming by tapping the satellite icon in the upper right and looking at the Latency field. If Latency is less than 3 seconds then RTK corrections are being used by the GNSS receiver.